Werkstoffprogramm für Shredderanlagen

Materials	Works Number	Hardness	Characteristics	Areas of use
Austenitic manganese cast steel	VM14	200 HB (550 HB)	Excellent ductility, hardness increases at it is worked	Bottom Grids, Anvils, Top Grids, Ejection Doors
Austenitic Cr-alloy manganese cast steel	VM 14 E	220 HB (550 HB)	As VM 14, however at the same time increased resistance against frictional wear.	Hammers, Ejection Doors, Impact Angles, Anvils, Hammer Rings, Impact Housings, Grinding Plates, Reduction Hammers, Side Plates
Q & T , martensitic Cr-, Ni-, Mo-alloy cast steel	NCM 35	450 - 500 HB	Good ductility, good resistance against impact and frictional wear	Baffle Plates, Impact Angels, Anvils, Bottom Plates, Side Plates
Q & T, martensitic Cr-, Ni-, Mo-alloy cast steel	NCM 55	36 - 56 HRc	Good ductility, very good resistance against impact and frictional wear	Hammers, Impact Rings, Impact Angels, Bottom Grids, Impact Housings, Rotor Caps
Q & T, martensitic Mn, Cr-, Ni-, Mo-alloy cast steel	VCKN 30	450 - 500 HB	Good ductility, good resistance against frictional wear	Rotor Caps, Bottom Grids
Q & T, martensitic Cr-, Mo-, V-alloy cast steel	G35 CrMoV 10-4	310 - 360 HB	Good ductility,good resistance against frictional wear	Rotor Caps